Product Information

Silberline Start

01AQUA PASTE® 554-C33

AQUA PASTE® 554-C33 Inhibited Aluminum Pigment

PRODUCT DESCRIPTION

AQUA PASTE 554-C33 is suitable for use in waterborne general industrial coatings.

-Non-leafing

-Fine particle size, silver dollar


PRODUCT APPLICATION

– Automotive
– General Industrial Coatings


TECHNICAL DATA

Grade

400 mesh grade

Screen Analysis (Max Retained)

99.9% minimum through 325 mesh

Non-Volatile By Weight (Target)

63.0% (+/- 2.0%) by weight

Non-Volatile By Volume (Calculated)

34.5% by volume

Specific Gravity

1.50

Bulking Gallons Pounds

0.080

Solvent

Mixture of mineral spirits, high aromatic and propylene glycol ether

Aluminum Flake Content (Calculated)

54.8% minimum by weight

Particle Size-Microns (Target)

16


INCORPORATION GUIDELINES

The recommended dispersion technique included the addition of sufficient co-solvent or vehicle co-solvent blend to the paste to develop a thick, creamy consistency under slow-speed mixing. After the development of a smooth, lump-free pigment slurry, total letdown can be completed with additional co-solvent and/or vehicle co-solvent blend. This grade, as supplied, is a paste and needs no additional mechanical shear to develop the aesthetic properties of the individual flakes. The only requirements for incorporation and dispersion into the vehicle are viscosity reduction, to overcome the cohesive nature of the paste, and minimum mechanical agitation to assure uniform incorporation throughout the vehicle. Excessive mechanical shear may damage the flake, thereby compromising gassing stability and changing its aesthetic value.

Limitations: This grade has been chemically treated to inhibit the aluminum-water reaction. However, under certain conditions, this reaction can still take place. The conditions which can affect this reaction are extremes in pH, excessive mechanical shear, and the chemical aggressiveness of the resin and additives. Because this reaction is a complex mechanism involving, perhaps, many of a coating’s constituents, Silberline recommends that coatings manufacturers evaluate this grade of aluminum pigment in their system to determine its own unique appearance and stability characteristics.

Caution: The use of high speed mixing equipment, such as Cowles dispersers, may distort the aluminum flake, resulting in poor appearance.


SAFETY AND HANDLING

Aluminum pigment should be stored in the original shipping container and kept tightly sealed. Store containers in a cool, dry, well-ventilated, and properly rated area. Avoid any conditions that will suspend or float the particles in the air, creating a dust cloud. Avoid all possible sources of ignition. For additional information, please refer to the Safety Data Sheet (SDS) for this product, available from Silberline upon request. An SDS is supplied with all samples of this grade.


All statements, information and data presented herein are believed to be accurate and reliable but are not to be taken as a guarantee, express warranty or implied warranty of merchantability or fitness for a particular purpose, or representation, express or implied, for which seller assumes legal responsibility, and they are offered solely for your consideration, investigation and verification. Statements or suggestions concerning possible use of this product are made without representation or warranty that any such use is free of patent infringement and are not recommendations to infringe on any patent. Copyright 2022 Silberline Manufacturing Co., Inc. All Rights Reserved.